Yaskawa Motoman Robotics

Training for Veterans

Motoman Technical Education Center is recognized by the State of Ohio Board of Career Colleges and Schools and is approved for the training of veterans. This approval allows military veterans and their immediate families who are entitled to funding under the GI Bill to receive an appropriate payment from the Veterans Administration for training received at the Motoman Technical Education Center.

The State of Ohio and the U.S. Veterans Administration recognizes only the programs listed below and not individual Motoman courses. Therefore, Veterans wanting to receive GI Bill funding must enroll in one or more of the following programs:

To view a program description, click on a program title. You can then register for the program by calling us at 937-847-3307.

Approving training for veterans was initiated by employees of Motoman, many of whom are military veterans, to find a way to allow veterans to receive additional training. The VA will make payments directly to the veteran as monthly living stipends. Students receiving training at the expense of their employers will still be able to receive stipends.

Operator’s Training Program

This program is designed specifically for non-programming, robotic system Operators. This introductory program teaches safe operation of the robotic system. Upon completion, each student should have the necessary skills to work safely in a robotic work cell and have a basic understanding of robot movement and fault recovery.

To complete the program, students must take the following two courses:

It runs approximately 21 hours, including self-study. No prerequisite required.

The price of this program is $1,100, which includes all course materials (manuals, handouts, etc.) This price does not include a $250 registration fee.

To Register, contact us at 937-847-3307.

Robotic Programming Program

This program is designed specifically for basic and advanced level Robotic System Programmers or for those who need to give some level of programming support. As a prerequisite, Basic Programming must be taken before all other programming courses.

To complete the program, students must take the following five courses:

This program runs approximately 92 – 115 hours, including self-study and depending on the controller selected. The price is $5,500, which includes all course materials (manuals, handouts, etc.) This price does not include a $250 registration fee. Courses do not run consecutively.

To Register, contact us at 937-847-3307.

Robotic Maintenance Program

This program is designed specifically for the maintenance technician responsible for electrical and mechanical troubleshooting and upkeep on Robotic cells. As a prerequisite, Basic Programming must be taken before the Ladder Programming and Maintenance courses.

To complete the program, students must take the following four courses:

It runs approximately 56 – 79 hours, including self-study and depending on the controller selected. The price of this program is $3,850, which includes all course materials (manuals, handouts, etc.) This price does not include a $250 registration fee. Courses do not run consecutively.

To Register, contact us at 937-847-3307.