FS100 Basic Programming with Material Handling
June 6 (2 - Seats Left), June 20, July 25, Aug 22, Sept 19
This course will run 4.0 days, Mon thru Thurs 8:30am to 4:30pm (26 Hours), with the exception of class starting on Tuesday (Dec 1st) thru Friday (Dec 4th).
If you require assistance,
please call 937-847-3307.
This course is an introduction to programming the FS100 controller. The course pertains to programming of press tending, case packing, machine tending, and palletizing cells. No prior knowledge of robot programming or the FS100 controller is required.
Primary topics include:
- Working safely in and around the robot cell
- Powering up/down
- Jogging the robot using all coordinate systems
- Modifying points, motion type and speed
- Adding position levels
- Checking specified point
- Recovering from alarms and errors
- Cutting and pasting instructions
- Programming I/O and control instructions
- Monitoring and using Arithmetic variables
- Creating and working in user frames
- Defining and using Position Variables
- Programming SFTON and SFTOF Instructions
- Multiple Tool Selection
- Monitoring Specific Outputs for Interference Zones
This course consists of classroom lectures, demonstrations, discussions and hands-on practice exercises. Covered topics are related to real-world examples and applications. To create an interactive and enhanced learning environment, class size is limited to 12. To perform the hands-on practice exercises, students are typically assigned 2 to a pendant at MTEC and no more than 3 to a pendant On-Site.
Students receive a course outline, objectives, and a manual, which details specific topics covered in the class. Students are urged to take notes, participate in discussions, and inquire about specific operating issues.
Training class schedules are subject to be changed without notice, based on training demands. All Training classes are held in the Miamisburg, OH Training Facility unless other prior arrangements have been confirmed.