for those with no previous NX100 experience!
call for class availability
This course runs 1 day, 8:30am until 3:45pm
Who Should Attend
The NX100 OVERVIEW Course is a basic overview designed for personnel who have never seen or used a Yaskawa Motoman NX100 controller robotic system. Not meant for robotic programmers, this course will teach safety in and around the robot cell, use of the programming pendant and basic troubleshooting. No prior knowledge of robot programming or of the NX100 Controller is required.
This 1 day condensed class gives an overview of how to work with an NX100 teach pendant and controller.
Students receive a copy of the NX100 Operator's Manual which details programming and editing instructions. Students are urged to take notes, participate in discussions and to bring up specific programming issues.
Yaskawa instructors cover topics which enable the students to understand the robot, manipulate the robot, and perform basic troubleshooting. An overview of the primary topics covered in the course is provided below: - safety in and around the robot cell - powering up and down - coordinate systems - jogging the robot - recovery from alarms and errors
The NX100 OVERVIEW is a 1 day course. This course typically closes out 60 days in advance. For information regarding course registration, or other training courses offered by Yaskawa Motoman Robotics Canada, contact our Training Coordinator at (905) 569-MOTO or your Regional Sales Manager.